Search results

Master switch on dash for me and a 3 way on each lamp, centre off then pure white and soft all in same lamp, took a bit of work but worth it

If you have a good thick ring yes, but better to go for only a few on one light fuse of around 10amps

A few springs on my baby, bump stops were fitted after the refit of axle.

I would have had a poll at rear of rack and a cross clamp to frame front down tube under the tank or handle bars, other wise good job. (y)

They can be got but dont turn up often, i have one, all other switched, alternative is one of these if light bothers you, the mask not the dollybird i mite add, well you never know.;)

WEll say you are using a phone for tv/vids , well to keep up id use the 2.1a port, if slow charge overnight i would use 1a, best to see what your device uses and always go a bit higher, never lower.

Mine in 9 years and not one failure, you should stop throwing darts at them. 😂

Great job and well done you. (y)

Many inverters can at best only deliver 2/3 of the so called rated power, I have a smart soft start nikkaI 600w constant, well in fact it will not run my 500w plug in wall heater, so I had to go down to 400w unit which now stays on without cutting out. Do you not have gas to heat things, much...

I used fence post brackets from the builders yard, couple of bucks.

My van has them all around.

Still running old style electric heater/bulbs, led are the must have.

I have two and think there poly, use a good control unit MPPT which will charge hab and starter batt

Welcome from Co Antrim, some amount of power lines going in and out of your van. 😂

Stick it on facebook market place, be gone in hrs

One thing i can say is, if using a large bank of batteries and charging from the engine, you may find the fan belts wear out fast or slip under load at first start, also alts my not last as long and brushes burn out faster.

I used a small soft start smart inverter rated at 600w and a mini fridge, works 100%

I have 200w solar and feeding into 180ah batts, make sure you are using a MPPT regulator, votronic has a 1am bleed to starter battery which is handy

The seatbelt bit is incorrect, from 89, seats have to be strapped and seats after 2006 were ment to be marked as conveyence, no longer required as makers could not agree on a motive mark for seats, mine were all looked at on first mot inspection, also ins co will not cover you with out belts...

Looks good, a few battery straps might be a good idea, and cannot caryr anyone in those unbelted seats, ok for eating at mind you. (y)