Search results

I use OneCNC and solidworks, so it would be dangerous to learn another set of commands. I still miss Autocad, but that was a pain in 3D.

How much work is done for you in this software. Does it have models of furniture that you can edit the sizes on or is it line by line?

You have to be very carful with older technology generators and switched mode power supplies and chargers. Not all are generator tolerant, and tend to go bang if not. Though I have noticed some of those open frame generators have better manners now. I'm believe it or not limited on space, and...

Also the generator was not happy with a very light load. One day it would be interesting to borrow one of those honda 1kva generators to see if they are quieter and better behaved than my cheapy from Machine Mart. Though I seldom use a generator these days.

It makes such a mess and often you can't get to the bit most needing it. I'll trim away anything I consider too far gone and chemically treat the rest.

After one day and a little solar help all is good in the world. The generator is ran for 3 hours and the batteries are topped up. Next was to run for 2 days on batteries Solar was not as good and 3 hours charging was not enough. Three and a half hours drive home was not enough to get...

You can, but there are easier ways ;)

We have a full size domestic cooker and wouldn’t be without it. I had caravan stuff when I lived in the back of a lorry, glad to be shot of it. Grill and oven in use now cooking my breakfast.

Just checked and my D2 and lighting are pulling just 1amp or 29watts on a 24volt system this evening.

Real world test taking place now in Hereford.

If you mean having the ignition on is the first click of the key. That should not do any harm. If you are worried about the battery, fit a BMV.

Yes Dave the heater needs to pump the coolant. This pump is normally combined with the heater. Sometimes it’s required to use a second or more pumps if your system is restrictive. There are many ways of plumbing these depending on what you are looking for. I use mine for engine preheating...

I think your hydronic 5 would be more than enough for all your water heating needs. Yes the water does need to be circulated all the time. Without knowing more about your setup I can't comment. Though crudely the heater needs a power supply, this is normally fused. Then it needs a start...

You should have most of what you need without spending much more. First thing 500W 240v element for the calorifier, you can you use a small generator without getting a hammering. I've seen many circuit diagrams of how to install this stuff, most seem overcomplicated. I'm convinced Mine is...

Should this not be an example of why you should research a product before buying it. I was told a story by a Castrol ex chemist. And also had an experience to back it up. Sales and marketing often do not use or consult the chemist when making claims about a product! Had a similar problem last...

You forget Dave, we're talking about a Dutch company, just imagine it could be twice as bad ;)

Wasn't so bad as most of this was over 10 years. Getting a fridge to do what I wanted was annoying for a few months. This years expenditure does seem daft, considering it will be up for sale soon. On the plus side I'm more confident about the new build.

Yes that would be the perfect answer. When I got Murky the link cable was seriously horrible. So I made a horrible cable with one end cut from a scrap car. For many years I have intended to replace it. Soon as the lid is shut, the memory of it goes away.

Makes a lot of sense Dave. My link cable is not the prettiest, so it would be a good idea to replace and alter it. The imbalance only shows up towards the end of charge btw.

I replaced the alternator regulator last night. Volts dropped to 28 on a fast idle. Charged the batteries again with the Victron charger and then tried running the engine again. Seemed to be holding around 28 volts. Interestingly the lower the idle speed was set the higher the voltage...