Search results

A strip of ally angle from the side cupboards/ or top bottom, just edging into the fridge door shut will hold it firm and some rubber stops/blocks at the back.

Slow down wildbus or you will blow a fuse for sure. 😂 (y)

My we el cheepo fridge has the back all inclosed and no comp to see, hit 38c when I was looking and maybe a tad higher, never gave a problem and cooled to 2c night and day.

Handy, think the charger/battery boiler is from the stone age, try a numax or other smart chargers.

Looks good, one thing i think to add is a input phase changer before the box.

Im 12v so a voltronic split charger/solar 200w for me and a switched relay to connect the alt/starter batt to the pleasure batts. I have a numax 10ah smart charger on board to do all batts in winter, all I do is drop the relay switch and all batts charged together, also handy for starting with...

Here at test station all the regs they showed me are as follows, seat belts front ok, rear 3 point or lap if no object in front to hit from about 88 to 2006 all with correct plate size under the floor unless its wood. 3 point only 2006 to 2012 then seats wear meant to be marked for conveyance <...

I dont like it one bit, too much Viking in my DNA, 17c is as good as I can stand

I found the doors leaked and no way to insulate, so off they came, mine is double over and under bed for 4 at rear, no boot as such unless the bottom bed not used.

Looks good, watch the weight of wood, I removed my rear doors and fitted s wheel rack and jerry can holders, 8 seats max for motorcaravan and Phg if over 3,5 ton which mine is.

An alt puts about 95% at best before decreasing its charging to almost zero even though it shows 14.2 to 14.4, there is a add on unit which tricks them to do the full monty, may have seen the units on ebay some time back, proper smart chargers and solar with a MPPT reg is the way to go, wildbus...

With being in the spraying game I can tell you the thing to look for is the CFM not pressure, anything that can reach 80 psi with a good Cfm and a heavier duty motor is what you should be looking at as the one mistericeman shows, thick power cables a must also, power from the battery with crock...

Master switch on dash for me and a 3 way on each lamp, centre off then pure white and soft all in same lamp, took a bit of work but worth it

If you have a good thick ring yes, but better to go for only a few on one light fuse of around 10amps

A few springs on my baby, bump stops were fitted after the refit of axle.

I would have had a poll at rear of rack and a cross clamp to frame front down tube under the tank or handle bars, other wise good job. (y)

They can be got but dont turn up often, i have one, all other switched, alternative is one of these if light bothers you, the mask not the dollybird i mite add, well you never know.;)

WEll say you are using a phone for tv/vids , well to keep up id use the 2.1a port, if slow charge overnight i would use 1a, best to see what your device uses and always go a bit higher, never lower.

Mine in 9 years and not one failure, you should stop throwing darts at them. 😂

Great job and well done you. (y)