domestic mixer tap

[trickydicky59]

Where can I get the bullet conecters to connect hose to domestic tails from mixer taps, I know there is a place, but can't find it. Just got a complete set of kitchen units and a sink.

 

[witzend]

Can't understand what you mean but between the flexible hose's that come with mixer taps and the house plumbing they usually fit a isolating valve but if it's not that you may find what you need here 15mm Isolating Valve Pack of 2 | Isolating Valves | Screwfix.com

 

[n brown]

or just warm up the hose and stretch it ,then hoseclip ,i do this on 15mm copper pipe no problem

 

[outtolunch]

is this what you are after

Fulham nozzle to 15mm compression - Fulham nozzles - Compression fitting

or on ebay a bit cheaper

15mm compression - 10mm fulham Nozzle | eBay

 

[hextal]

The Monobloc mixer tap I used came with a pair of braided tails with 1/2bsp female connections on the ends. So I bought a pair of these.
Barbed & Threaded BSP Fittings Male BSPT Hose Tail Brass large/small sizes | eBay

 

[outtolunch]

thats a posh tap if it came with braided tails I fitted one today that just had plain 15 mm copper pipe ends but then it was an own brand budget model

 

[hextal]

Eeyup, thas right about mi bein posh like....

One thing I found with the mixer, possibly specific to ours, was that on partial opening the pump would pulse at full whack. So we installed a pressure tank and its waaaaay better.