Search results

do a seaerch on here look for for charging ,batterys,lesuiere battery ,split charge , relay,this has so many threads on here you should find one and ihave particpated in a few so lokk back through my post you should find your answer in so many ways

BEFORE YOU PLY LINE paint the inside of the van where you think the waters coming in then let it dry then plaster with vaseline or grease on top of the paint and it will encourage the water not to hang around dont forget to paint both side of the hole you drill as you will be exposing metall...

now there a nice thought daisy pole dancing just jesting coming along nicely well done

well if you get it now then you can test as you wire stuff in that way you wont have to rip stuff out to find a fault and you can always charge it up at home

just type in telescopic table legs into google it come up with lot of choices and budgets

more than willing to pass mine on

just thought of siting gas bottle dont forget that you will have to drill through the floor to put in a dropout vent so think about where it will come out underneath {dropvent best descriptoin bit like a sink plughole to clear the gas in event of a leak as gas is heavy than air} and do you have...

daisy can we have close up of the panel down the far end and if possibble a picture of the back of it please as that wuil give us some idea of what you have there do you have any thing out side the van on the body work like a round plug i see you still got bambi i would layit out like the bambi...

IMPORTANT DO CHECK WHERE YOU PUT THE WIRES AND THAT YOU DO NOT PUT A FIXING THROUGH THE CABLES if in doubt then take photos with a tape measurre lying along side it so you have some idea of where the cables are I would put the wiring in first before fixing panels then do the panels and then...

what do you have at the moment do you anything like a zig control panel and do you want a seperate 240 volt supply as done by firefox http://www.youtube.com/watch?v=39pQ4aW-8ls any thing else there are more videos done by vernon on there as well

very nice but dont let funky see it he will have your headlight out and in his pocket before you can blink nice to have solid fuel stove as i would always have a kettle on tickover and just a small fire would keep it warm

could you not make a center piece that slide in to fit across the rear doors to give you a walk through so just slide out in summer and turn round to give you a ushape looking out through the rear doors

well did post this ages ago somwhere burried deep in the forum nice to see it resrected to give some help to others

just be carefull when cutting it that it dont get to warm ,dont see you should have to uncarpet it well dril all four corner the join up underneath remove square of carpet well cut across corner to center so you you have four triangles then cut out carpet carefully then cut once measure...

well at least you know it watertight lol

ship porthole washing machine door

fit a washing machine door in the sides seen it done on old merc on flea bay

plus paint the edges with at least two coats when they did my windows on conversion they didn't paint them well if they did they didnt do a good job they need taking out and painting properly but that will have to wait till i can afford to get it done

one tip i read some where once you have floor in get seating cushions layout on floor and cardboard templates for cooker unit etc and play around with layout it might work in your head but not in reality one right photo it