Recent content by trevskoda

Stainless will bo ok in its self, do vent it for cooling.

Dont think liths require venting but a little gap to prevent over heating may be a good idea, also remember on you build never let alloy near steel as galvanic corrsion will eat the alloy away, do use some for of insulator between the too. Put some holes in the battery box to let air flow around...

I built my toilet wash room in wood and then covered with GRP with a light cream colour mix.

3 way old gas fridges are old hat, go small electric if you have solar and 200ah battery bank, mine works easy over 24 hrs witout sunlight, never flattened a battery bank all year round, except lowish nov/dec and early jan.

Maybe all 3 sites under one roof, just differant sections, wild camping to me always seemed like tent brigade, not what we do, motor home wildies or motorhomer comunity sounds better, you shout, im going no 3.

I would say its very dificult to do what you require, best bet is to find a way to lower seat frame to swival unit.

A inverter to charge a laptop is over the top, many do this but as above a cigy charger which ups the voltage is cheap and simple, look online for one to do your l top. One thing i notice from your first post is no polarity change over switch in front of fuse box and between mains input plug, it...

If you want it reg as a motorcaravan then look up the rules etc bed size water tank cooking waste tank windows etc, some rules have been dropped like stickers all over the outside etc, good luck.

Police will look at her ph to see if it was in use, happened to me many years back when i rebuilt a skoda estelle with full respray, on the rd a few weeks when a idiot rear ended me at roundabout in a tranny van, car scrap, he was charged for using a mobile. Cops said he was speeding as well...

Me to but to many pillocks out there these days, a lot on drugs.

My beds are down the back well out of way.

What happens if a panel gets hit in a accedent and requires welding, i used bubble foil and rockwool as easy to remove internal panel and get welding etc sorted if its a tin panel van you are building.

My small table top is sealed at the back so no use fitting fans etc, however i did put vents at top so air would get round the wood at back and sides.

Brotherinlaw has just went and came back from england with a suposidly built camper< merk>is not reged as so but a complete holox to be honest. He did not ask or tell anyone, now he finds nothing works in it and electrics look like a 3 year old wired it up, supossed to have been done by a pro...

Must be high tensile bolts, same goes for adding internal seats for travel.