Sprinter seats wanted

[Sprinter 1 cup]

I like diffent seats. As ours don't have arms
The bases can stay if it is needed.
Sprinter has seat belt attached to seat at both sides . Help needed to what would fit ???

 

[wildebus]

I fitted Ford Galaxy Swivel Seats to my VW LT, which has identical Seat Bases to the Sprinter Mk1. In fact the second single base I got to replace the Double Seat was a Sprinter Base.

If you click on this link - https://www.wildebus.com/clarence-the-office/, there is a section on the Seat Bases and the Seats themselves.

They have been excellent seats and would get the same again no hesitation.

 

[Sprinter 1 cup]

Yes that's looks in the link matey and I see the bases fit different. I tried to fit the swivel base out of a fiat decato but it just fell into the base of mb.
So I'll have to get help.

 

[wildebus]

Yes that's looks in the link matey and I see the bases fit different. I tried to fit the swivel base out of a fiat decato but it just fell into the base of mb.
So I'll have to get help.

How about going to an engineering company and get them to sell you a sheet of suitably sizeded and suitably thick metal which you can secure to the swivel plate first, and then to the seat base? That would give you a load of flexibility to chose a seat setup.
It should not be expensive at all to do that and would only add a few mm to the height.

Looking at my Ducato seat bases, they do look a bit small generally than the Sprinter ones (not measured. just going by appearance).

 

[Red Dwarf]

Try cabmasters.com, an Aladdin’s cave of van parts!