Recent content by Alec

  1. Cutting Ribs overhead Cabin ?

    Have a look here :- Pages 2.15 and 2.16
  2. Distribution Board

    This is the 12 volt fused ditribution unit I have used from ebay no. 221166230726 Alec.
  3. Distribution Board

    Clearance may be required around Solar Controller for heat control, my Tristar 45amp MPPT required 150mm clearance top and bottom .Also....heat exchanger may be adding to your problems.....see extract from Victron 100/30 manual :- ● Mount vertically on a non-flammable substrate, with the power...
  4. Vent Windows

    Paul at Leisurevehiclewindows from Corby, supplied my windows...not the cheapest but fitted well. Found him most helpful.
  5. Alternative to bubble rap silver, closed cell 2m x 50cm or this

    My thoughts when mentioning the weight of water, was that it would need support, restraint, and be positioned carefully to avoid imbalance to the loading of the Sprinter. Much the same as your thoughts on baffles to restrict load movement.
  6. Alternative to bubble rap silver, closed cell 2m x 50cm or this

    250 ltr. Water ? ...............thats 1/4 of a tonne !!
  7. Off-Grid'ers or Full-Timers - what's your Leisure Battery Amp Hours and types ? TIA

    Current van, since 2013, used year around has two 6 volt T105 Trojans, now six years old and good as new. In build van will have four T105 Trojans suplied by Sterling 60 Amp B2B and 480 Watt Solar through MPPT controller. Reason for much larger set up is much larger compressor fridge and better...
  8. Ducato load space drawings

    Usefull stuff here.....
  9. Old site back?

    Well,........I wasn't deleted !
Top